Milk storage silo manufacturers
Milk storage silo manufacturers are a kind of storage tank for heat preservation and storage of raw milk. It consists of a round stainless steel inner cylinder and a stainless steel outer shell. The middle layer is filled with polyester foam. It serves as a thermal insulation, and ice bank milk tank manufacturers in India which is good for storing heat. The top of the tank has a thermometer. It makes it easy to check the milk’s temperature without it needing to float. The mill is sent to the dairy processing facility. There, it is often chilled with a plate cooler to a temperature of 10°C or less.
Tank design requirements include the material, insulation, and three layers. The layers have jacket cooling to stop the milk in the silo tank from heating up. You need to have good Gott temperature performance. In general, milk should not increase more than 2-3 °C after being stored for 24 hours. Vertical milk storage tank manufacturer a side-stime liquid level gauge and temperature sensor to measure milk and ice water. Inlets and outlets control them. A guardrail and sight glass are installed. The tank also has a side manhole and a cleaning mechanism.
Tank Configuration for Milk Silo
- Tank body of Silo
- One oval manhole on the airtight side.
- High or low agitator (960 rpm).
- PT thermometer with a range of 0 to 100°C
- Two CIP cleaning balls that rotate 360 degrees (top and side bottom).
- Only one aseptic sample valve
- Dirt penetrating and repelling snails
- Inlet and outlet
- Replaceable level sensor
- Stairs with safety loops
- A fence to protect the upper tan
- Install a cooling jacket under the tank if necessary
- Overflow opening
Contents of a milk silo tank
Food-grade materials make up the body of the tank ice bank milk tank manufacturers in India. The inner layers of the tank bottom and body measure 64.0 mm and 83 mm respectively. The outer shell is made of Iso 2 mm and 1.5 mm polyurethane foam insulation, and the jacket is 1.5 mm thick. The temperature of the fresh milk in the tank after a day is within ±1.5% of its original temperature. milk storage tank manufacturers the steel plate has a film to protect its surface. It is made by treating it with either weld passivation or polishing.
The tank body is a vertical cylinder. It has a low bottom cone with a 30-degree taper, a top cone with a 30-degree taper, and a spinning plate at the milk outflow.
It can be used for secondary cooling while milk is stored. The ice water jacket is 1.5 meters below the tank. It can be used to pre-cool the tank before milking. horizontal milk storage tank manufacturers the tank base is made from 304 stainless steel and has a 12 mm thickness. The tank frame has a structurally reinforced design.